Publicité
Les langues disponibles
Les langues disponibles
Remove the cardboard wedge between
7
the movement and the dial.
Where the clock is to be installed:
8
drill 4 holes according to the layout and
dimensions indicated below for fixing the
bracket.
Insert the threaded rods (chemical seal)
9
into the drilled holes. It is also possible to
use anchor studs.
Place the washers and the struts on the
10
threaded rods.
Run all the cables through the cable
11
glands of the IP65 plate and then through
the bracket arm.
If the wiring is routed from above, make
sure that the cables are laid out as
shown opposite (loop) before running
them through the cable glands in order
to prevent water ingress.
12
Place the sealing plate on the mounting.
Apply a silicon seal between the IP65
13
plate and the bracket arm's plate.
Secure the whole assembly with washers
14
and nuts.
Replace the face of the clock opposite
15
the grommet after first cleaning the seal
of this face and applying silicone oil on it.
Tighten the four cover screws (1.2 Nm)
16
on this clock face.
Reconnect the flat cable (identified as B)
17
going to the movement on this face (limit
its length using the cable clip).
Before replacing the clock's face on the
18
grommet side, proceed with the clock's
internal cabling.
Refer to the following chapters of this
manual according to your model.
If
subsequent
required, remove only the clock's
face on the grommet side.
Access to the battery (optional)
requires removal of the face opposite
the grommet.
Once the clock has been wired, clean the
19
seal on the clock's face on the grommet
side, then apply silicone oil on it.
Realign this face and reconnect the flat
20
cable (identified as A) from the electronic
card to the movement located on the
disassembled face.
44
maintenance
is
X8
J3
A3
B3
EN
M8
3mm
I3
H3
D3
F3
C3
Publicité
