Hinkley 60 FACET Manuel D'instructions page 12

INSTALLING THE LED ASSEMBLY AND GLASS SHADE
WARNING: Before starting installation, disconnect the power by turning off
the circuit breaker or removing the fuse at fuse box. Turning power off
using the fan switch is not sufficient to prevent electric shock.
If you do not plan to install the light kit with your fan at this time, skip step 2
& 4.
Remove the 1 of 3 screws from the posts of the light kit
decorative housing and keep it for future use. Loosen the other 2
screws. (Do not remove)
While holding the LED light kit under your fan, make the polarize
2
plug connections: (Fig. 1)
- Red to white
- Black to black
Place the key holes on the LED assembly over the 2 screws
3
previously loosened, turn the light plate until it locks in place at the
narrow section of the key holes. Secure by tightening the 2 screws
previously loosened and the one previously removed. (Fig. 1)
Raise glass shade up against adapter plate and secure it to the
4
fan by turning the glass shade clockwise until snug. DO NOT
OVERTIGHTEN.
5 Restore power and your light kit is ready for operation.
NOTE: The metal light cover included with your fan is an option to replace
the glass for the light in the event that you prefer not to use the light feature
of your fan. The metal light cover is not necessary for the light operation; it
can be saved for later use if desired. (Fig. 2)
10 | hinkley.com
Wire connectors
Adapter plate
LED
assembly
Glass
Shade
Fig. 1
Adapter plate
Metal
light
cover
Fig. 2
Screws