Hinkley 60 FACET Manuel D'instructions page 10

FINISHING THE INSTALLATION
Remove two of the four fan motor mounting screws from
1
the mounting bracket and loosen the other two screws.
Remove the fan motor from the mounting bracket hook, and
2
while holding the fan motor under the mounting bracket.
Place the key holes on top of the fan motor over the two
3
screws previously loosened from the mounting bracket.
Turn the fan motor until the fan motor locks in place at the
narrow section of the key holes.
Securely tighten the two mounting bracket mounting screws
4
previously loosened and the two previously removed.
INSTALLING THE MOTOR HOUSING
Raise the motor housing up against the mounting bracket,
1
the four supports inside the housing should be placed
against the four studs on mounting bracket, twist the
housing clockwise until snug.
08 |
hinkley.com
Screws
Mounting
bracket
Fan motor
Mounting
bracket
Studs
Motor
housing