Télécharger Imprimer la page

Hinkley 60 FACET Manuel D'instructions page 11

Publicité

Les langues disponibles

Les langues disponibles

INSTALLATION OF THE BLADES
WARNING: To reduce the risk of personal injury, do not bend the
blades while installing, balancing the blades, or cleaning the fan.
Align the holes in the blade and the fan motor assembly
1
and secure with a blade attachment screw. lock washers
and flat washer.
2
Repeat this procedure with the remaining blades.
INSTALLING THE ADAPTER PLATE
NOTE: Be sure the power is off before installing.
Remove one of the three screws on the mounting hub
1
located on the fan motor. Loosen the other 2 screws. (Do not
remove)
2
Pass the light wires through the center hole of the adapter
plate.
Place the key holes on the adapter plate over the 2 screws
3
previously loosened, turn the adapter plate until it locks in
place at the narrow section of the key holes. Secure by
tightening the 2 screws previously loosened and the one
previously removed.
Blades
Flat washers
Lock washers
Screws
Mounting hub
Adapter plate
Screws
©2023 Hinkley Lighting, Inc.
| hinkley.com |
09

Publicité

loading

Ce manuel est également adapté pour:

905860f905860fmb-ldd905860fmw-ldd