Virutex FC116U Mode D'emploi page 22

"N3"
"Nt"
"N2"
N2-N3= X mm
V
N2-N3= X mm
S2
S1
S
22 - FC116U / Operating instructions
All manuals and user guides at all-guides.com
N1
"rs"
"rs1"
S1
"rs"
"rs1"
12. TRIMMING THE FITTING FOR THE FRONT PLATE OF THE
LOCK
Check that the trimmer is disconnected from the
mains.
CHANGING THE TRIMMING
attach a mortising bit of the correct size to the machine, fo-
llowing the instructions in section 6 of the manual.
MEASURING, MARKING REFERENCE POINTS AND PLACING
THE FC116U ON THE DOOR
the two edges of the front of the lock, giving you measurements
Hold the machine against the door, aligning the upper edge of
the lock box and the front plate for the lock.
which is X mm in the direction of the side with the greater mea-
in the alignment of the machine's trimming path with the centre
of the front plate for the lock.
ADJUST THE TRIMMING PATH
corresponding division of the measurement NT, using the scale
-