Jägermeister JEMUS TAP MACHINE Manuel Du Propriétaire page 17

Bottle stopper insertion and removal
Figure 8 - Screw On Bottle
Stopper
Figure 9 - Screw On
Figure 10 - Seated Step 2
Figure 11 - Install - Step 3
All manuals and user guides at all-guides.com
Model JEMUS bottle stoppers are screw
on style. This stopper used in conjunction
with the Model JEMUS bottle well
assembly supports up to 1 liter bottles
without the use of a bottle cage. Do
not use these stoppers in older model
Jägermeister Tap Machines.
IMPORTANT NOTICE:
WHEN REPLACING EMPTY BOTTLES
DO NOT DISCARD OR THROW THE
BOTTLE STOPPERS AWAY.
THE BOTTLE STOPPERS ARE TO BE
REUSED AND ARE NOT DISPOSABLE!
Step 1
Remove the cap from the Jägermeister
Bottle and position the Bottle Stopper
above the Bottle.
Step 2
Verify the internal washer is in place.
Screw onto the threaded neck of the
bottle.
Screw on tightly but do not over tighten.
A correctly installed bottle stopper will
ensure a tight seal between the bottle
stopper neck and the bottle.
Step 3
Unsnap the three (3) dust caps from the
bottle well assembly. Carefully and slowly
turn the bottle upside down and position
it directly over the machine. If any
Jägermeister begins to drip ensure the
bottle stopper is securely screwed on.
17