Jägermeister JEMUS TAP MACHINE Manuel Du Propriétaire page 16

All manuals and user guides at all-guides.com
Placing the Machine on the Bar
Place the JEMUS on a flat, level surface with a MINIMUM of 1 inches
of clear space at the rear of the unit and 1 inch MINIMUM on both sides
is required to permit adequate airflow for the refrigeration system.
An additional 5 inches at the front of the machine is necessary for the drip
tray/filter access that is provided with the unit.
ENSURE THE UNIT IS ON A FLAT LEVEL SURFACE TO ENSURE
PROPER OPERATION. DO NOT PLACE THE UNIT ON A FRONT TO
BACK OR SIDE TO SIDE ANGLE. DO NOT REMOVE THE LEGS FROM
THE MACHINE. FAILURE TO PROVIDE ADEQUATE CLEAR SPACE AT
THE REAR OF THE MACHINE WILL RESULT IN IMPROPER CHILLING
OF THE JÄGERMEISTER OR POSSIBLE DAMAGE TO INTERNAL
COMPONENTS.
Tap Handle Installation
The Model JEMUS uses a fully functional draft beer type faucet and
requires an acrylic handle. The handle is packaged in the drip tray. Locate
the acrylic handle and screw it on the top portion of the faucet. DO NOT
OVERTIGHTEN THEN HANDLE ON THE FAUCET. OVERTIGHTENING
MAY DAMAGE OR BREAK THE HANDLE AND/OR THE FAUCET STEM.
The finger grooves on the back of the handle should be facing to the rear
of the machine. Use the adjustment on the faucet to tighten in place.
Once installed correctly, the flat portion of the handle will face the user.
Figure 7 – Handle In Place
16