HEIDENHAIN ND 7000 Guide D'utilisation page 21

4.2.2 Mounting on Duo-Pos stand
You can attach the Duo-Pos stand to the product at a 20°
or 45° angle.
Use the provided M4 x 8 ISO 7380 hexagon socket
screws to fasten the stand to the lower threaded holes
on the rear panel
Comply with the permissible tightening torque
of 2.6 Nm
Using the mounting slots (width = 4.5 mm), screw the
stand to a supporting surface
or
Set up the device freely at the desired location
Route the cable from behind through the two supports
of the stand and then through the lateral openings to
the connections
Further information: "C", Page 4
Dimensions of the Duo-Pos stand
Further information: "J", Page 186
4.2.3 Mounting on Multi-Pos stand
Use the provided M4 x 8 ISO 14581 countersunk head
screws (black) to fasten the stand to the threaded
holes on the rear panel
Comply with the permissible tightening torque
of 2.6 Nm
Using two M5 screws, you can also optionally screw
the stand to a supporting surface from the bottom
Adjust the desired angle of inclination
To fix the stand: Tighten the T25 screw
Comply with the tightening torque for
screw T25
Recommended tightening torque:
5.0 Nm
Maximum permissible tightening
torque: 15.0 Nm
Route the cable from behind through the two supports
of the stand and then through the lateral openings to
the connections
Further information: "D", Page 4
Dimensions of the Multi-Pos stand
Further information: "K", Page 187
HEIDENHAIN | ND 7000 | Installationsanleitung | 05/2018
4.2.4 Mounting on Multi-Pos holder
Use the provided M4 x 8 ISO 14581 countersunk head
screws (black) to fasten the holder to the threaded
holes on the rear panel
Comply with the permissible tightening torque
of 2.6 Nm
Mount the holder with the supplied M8 screw, the
washers, the handle and the M8 hexagon nut to an
arm
Adjust the desired angle of inclination
To fix the holder: Tighten the T25 screw
Comply with the tightening torque for
screw T25
Recommended tightening torque:
5.0 Nm
Maximum permissible tightening
torque: 15.0 Nm
Route the cable from behind through the two supports
of the holder and then through the lateral openings to
the connections
Further information: "E", Page 4
Dimensions of the Multi-Pos holder
Further information: "L", Page 187
23