HEIDENHAIN ND 7000 Guide D'utilisation page 20

3.4 In case of damage in transit
Have the shipping agent confirm the damage
Keep the packaging materials for inspection
Notify the sender of the damage
Contact the distributor or machine manufacturer for
replacement parts
If damage occurred during transit:
Keep the packaging materials for
inspection
Contact HEIDENHAIN or the machine
manufacturer
This applies also if damage occurred to
requested replacement parts during transit.
3.5 Repackaging and storage
Repackage and store the product carefully in accordance
with the conditions stated below.
Repackaging the product
Repackaging should correspond to the original packaging
as closely as possible.
Re-attach all mounting parts and dust protection
caps to the product as received from the factory, or
repackage them in the original packaging as received
from the factory
Repackage the product in such a way that
it is protected from impact and vibration during
transit
it is protected from the ingress of dust or humidity
Place all accessories that were included in the
shipment in the original packaging
Further information: "Items supplied and
accessories", Page 21
Enclose all the documentation that was included in the
original packaging
Further information: "Storage and distribution of the
documentation", Page 18
If the product is returned for repair to the
Service Department:
Ship the product without accessories,
without measuring devices and without
peripherals
Storage of the product
Package the product as described above
Observe the specified ambient conditions
Further information: "Specifications", Page 27
Inspect the product for damage after any transport or
longer storage times
22
4 Mounting
4.1 Overview
This chapter describes the mounting of the product. It
contains instructions about how to correctly mount the
product on stands or holders.
The following steps must be performed only
by qualified personnel.
Further information:
Page 20
4.2 Assembly of the device
General mounting information
The mount for the mounting variants is provided on the
rear panel. The mounting hole pattern corresponds to a
grid of 50 mm x 50 mm.
Further information: "H", Page 185
The material for attachment of the mounting variants on
the device is included in delivery.
You will also need the following:
Torx T20 screwdriver
Torx T25 screwdriver
Allen key, width A/F 2.5 (Duo-Pos stand)
Material for mounting on supporting surface
The unit must be mounted to a stand or a
holder to ensure the correct and intended use
of the product.
4.2.1 Mounting on Single-Pos stand
You can attach the Single-Pos stand to the product at a
20° angle.
Use the provided M4 x 8 ISO 14581 countersunk head
screws to fasten the stand to the upper threaded
holes on the rear panel
Comply with the permissible tightening torque
of 2.6 Nm
Fasten the stand with two suitable screws from above
to a supporting surface
or
Attach self-adhesive rubber pads to the underside of
the stand
Route the cable from behind through the opening of
the stand and then through the lateral openings to the
connections
Further information: "B", Page 4
Dimensions of the Single-Pos stand
Further information: "I", Page 186
HEIDENHAIN | ND 7000 | Installationsanleitung | 05/2018
"Personnel qualification",