Phantom Powering; Using Your Microphone - AKG C 1000 S Mode D'emploi

Masquer les pouces Voir aussi pour C 1000 S:

Table des Matières

Les langues disponibles

2 Interfacing

2.3 Phantom

Powering

Fig. 4: Connecting

to a balanced input

with phantom

power.

Refer to fig. 4.

Note:

3.1 Installing the

PPC 1000 or

PB 1000

Fig. 5: Installing the

PPC 1000/PB 1000.

Refer to fig. 5.

Important!

1. Use an XLR cable (e.g., the optional MK 9/10 from AKG) to

connect the microphone to a balanced XLR input with

phantom power.

2. Switch the phantom power on. (Refer to the instruction

manual of the unit to which you connected your C 1000 S.)

The microphone will automatically switch from battery

mode to phantom power mode and deactivate the

BATT CHECK LED.

Therefore, you do not need to remove the battery when

phantom powering the microphone. The BATT CHECK LED

will remain dark in phantom power mode.

Unscrew the wire-mesh cap.

Slip the attachment (1) on the microphone capsule (2) to the

stop, slightly turning the attachment (1) as you push it home.

When installing or removing the PPC 1000 or PB 1000

attachment, make sure to grip the capsule (2) and rubber

Table des Matières