Télécharger Imprimer la page

Kroll TE80 Notice D'instruction page 12

Publicité

Les langues disponibles

Les langues disponibles

TE80, TE100
Temperature, humidity degree and operating
conditions have influence on capacity of the
appliance. In winters with continuous frost,
when the weather is dry or in summertime, the
air-humidity may be very low (30 %). In these
cases the devices have only low or even no
efficiency. If no means of humidity measure-
ments are at hand, you can approximately
check the humidity with the hygrostat: the
appliance must not be under tension! Turn
slowly the knob of the hygrostat anticlockwise.
The flash above the knob shows approxi-
matively reached humidity-degree by a click
sound.
2.8 Setting into operation
1
7
1
Working hours-meter
2
Normal operation dehumdifying
3
Sensor malfunction
4
Defrosting
5
System OFF by excess temperature
6
System OFF by hygrostat
7
Power cord with plug
8
Main switch
9
Switch heater
10
Hygrostat connector
2.8.1 LED - Defrosting
The compressor turns, the fan is off. After
defrosting the device switches on again.
The device is equipped with an indication for
eventual malfunction of the sensing elements,
which control important values. In case of a faulty
sensing element, the device will turn off and the
LED „Sensor malfunction" will flash.
10
All manuals and user guides at all-guides.com
Important
2 3
4
5
6
8
9
10
Attention
Connect mains plug to a socket with
16/Amp. fuse and earthing contact. Adjust
appliance to desired room humidity level.
Turn main switch to ON. The appliance works
permanently.
2.8.2 How to set the automatic humidity
control
1.
Your dehumidifier can be equipped with an
adjustable humidistat (hygrostat) (in option).
When the hygrostat is not connected, the
appliance works also, but without automatic
control.
2.
The humidistat knob turns clockwise.The
size of the room, the relative humidity and
the temperature will influence your setting.
Start it first by selecting the midway
position.
Bild 1: Hygrostat
3.
Once set into operation,the device works
until the set humidity is reached. Then the
unit will stop and start by itself. It is maintai-
ning the humidity you have selected.
4.
If you want to remove more moisture, rotate
knob clockwise.
5.
In extreme conditions, rotate the knob
clockwise to final position. At this setting,
your dehumidifier will operate continuously
regardless of the amount of moisture in the
air.
English
h

Publicité

loading

Ce manuel est également adapté pour:

Te100