LENCO Discman Manuel De L'utilisateur page 10

Volume Control
Press the VOLUME + / - button to change the volume. This CD player has a hearing protection and will limit the volume
and give you a warning when the volume becomes too high; you have to press the ENTER (12) button to confirm that
you want to increase the volume, then press the VOLUME + (3) button to increase the volume level.
Adjusting the DAB+ / FM Reception
The earphone wire serves as the antenna. Therefore fully extend the earphone wire and place the unit to a location to
ensure a good DAB+ / FM reception.
DAB+ OPERATION
The first time in the DAB+ mode, it will automatically scan for available DAB+ stations. Wait until the scanning has
finished. The display will show the scanning progress. After scanning it will tune to the first station.
Auto Scan
1. Turn on the unit in DAB+ mode.
2. Press and hold the SCAN button to start auto-scanning the available stations.
Manual Scan
By using the manual scan operation, it can help you to adjust the unit position or search station that is missed while
auto scanning.
1. Turn on the unit in DAB+ mode.
2. Press and hold the MENU button to access the menu control.
3. Press the or
4. Press the or
5. Press the ENTER button to confirm. Adjust the unit position for the best reception if necessary.
6. To select another channel (5A-13F), press the
7. When the station is found, press the ENTER button to select.
8. To quit manual scan, press the MENU button repeatedly.
Tuning
After scanning all the available DAB stations, press the
press the ENTER button to tune to this station within a few seconds.
Storing DAB+ Presets
You can save up to 30 DAB+ stations.
1. Tune to the station you wish to store.
2. Press and hold the PRESET button, "Preset Store" will be displayed.
3. Press the or
4. Press the ENTER button to store.
Recall Stored DAB+ Presets
1. Press the PRESET button, "Preset Recall" will be displayed.
2. Press the or
3. Press the ENTER button to recall.
button until "Manual tunel" is displayed and then press the ENTER button.
button to select the desired channel (5A-13F).
button to select the desired preset number to store.
button to select the desired preset number to recall.
or button and then press the ENTER button to confirm.
or button to display and navigate the station list. Then
10