Falltech 11 FT-X Web Class 1 SRL-P Manuel D'instructions page 9

5.1 Single SRL Installation to Full Body Harness
Installation for Single-leg configuration of the FT-X Web to the dorsal D-ring of a full body harness
follows the steps listed below:
Step 1: Connect an approved carabiner through the swivel eye above the housing
Step 2: Connect the approved carabiner with SRL to the dorsal D-ring of the full body harness.
Step 3: Connect the leg-end connector of the SRL to the anchorage or anchorage connector. See
Figure 3.
5.2 Single SRL Installation to Anchorage
SRLs with large opening rebar hooks for leg-end connectors are not permitted for this type of
installation due to incompatibility. See Section 4.2 Installation for Single-leg configuration of the FT-X
Web to an anchorage or anchorage connector follows the steps listed below:
Step 1: Connect an approved carabiner through the swivel eye above the housing
Step 2: Connect the approved carabiner with SRL to the anchorage or anchorage connector.
Step 3: Connect the leg-end connector of the SRL to the dorsal D-ring on the full body harness. See
Figure 4.
9
Figure 3 - Attaching Single-leg FT-X to FBH
A
Anchorage
B
Leg-end Connector
C
Energy Absorber
D
Lifeline
E
SRD Housing
F
SRD Integral Swivel Eye
G
Carabiner
H
FBH Dorsal D-ring
Figure 4 - Attaching Single-leg FT-X to Anchor
A
Anchorage
B
Carabiner
C
SRD Integral Swivel Eye
D
SRD Housing
E
Lifeline
F
Energy Absorber
G
Leg-end Connector
H
FBH Dorsal D-ring