Evermount EM-FT2B Instructions page 4

Part 3 – Final Assembly
1. With the help of another person, carefully lift your flat panel and place it on the wall plate. Do not release
until the mount arms are securely hooked onto the wall plate.
2. Insert the safety bar at the bottom of the mount to prevent the flat panel from being lifted from the wall
plate. A padlock can be inserted into the end of the bar for additional security (see Fig.8).
IMPORTANT: The safety bar should be used at all times to prevent the flat panel from being accidentally
knocked from the mount.
Part 4 – Operation and Adjustment
1. To change the tilt angle of your flat panel, hold the flat panel firmly with one hand and rotate one of the tilt
adjustment knobs towards the flat panel (away from the wall) to unlock the tilt. Make sure you rotate the
knob fully. Carefully move the flat panel to the desired position, and then return the tilt adjustment knob
to its original position to lock the flat panel in place. Do not release your flat panel until the tilt is
locked.
2. Periodically clean your mount with a dry cloth. Inspect all screws and hardware at regular intervals to
ensure that no connections have become loose over time. Re-tighten as needed.
4
All manuals and user guides at all-guides.com
Padlock (optional,
not included)
Fig. 8
Safety bar
FT2B.ME.062011.IM