Evermount EM-FT2B Instructions page 2

Part 1A - Mounting the wall plate to dry wall
1. Use a high quality stud finder to locate two adjacent studs where you wish to install your mount. Mark both
edges of each stud to help identify the exact center.
NOTE: You must use the center of each stud to avoid cracking or splitting the wood during installation.
2. Place the wall plate against the wall and level it using the integrated bubble level.
3. While another person holds the wall plate in position, mark four locations (two per stud) for securing the
mount to the wall (see Fig.1).
4. Set the wall plate aside and drill a 6 mm (1/4") pilot hole at each marked location.
Place the wall plate back against the wall and attach it using the lag bolts (A) and lag bolt washers (B) pro-
5.
vided (see Fig. 2). Do not over-tighten these screws. Ensure that the wall plate remains level after both
screws are secured.
Part 1B - Mounting the wall plate to concrete
Place the wall plate against the wall in the desired location and level it using the integrated bubble level.
1.
While another person holds in the wall plate, mark four evenly spaced locations on the wall for securing
2.
the mount (see Fig. 3).
3. Set the wall plate aside and drill a 10 mm (3/8") hole at each marked location. Remove any excess dust
from the holes.
4. Insert a concrete anchor (C) into each hole so that it is flush with the concrete surface (see Fig. 4). A
hammer can be used to lightly tap the anchors into place if necessary.
NOTE: If the concrete wall is covered by a layer of plaster or drywall, the concrete anchor must pass
completely through the layer to rest flush with the concrete surface.
5. Place the wall plate back against the wall and attach it using the lag bolts (A) and lag bolt washers (B)
provided (see Fig. 2). Do not over-tighten these screws. Ensure that the wall plate remains level after
all screws are secured.
2
All manuals and user guides at all-guides.com
Fig. 1
Fig. 3
Fig. 2
Fig. 4
FT2B.ME.062011.IM