Evermount EM-FT2B Instructions page 3

Part 2 – Attaching the mount to the flat panel
IMPORTANT: Use extra care during this part of the installation. If possible, avoid placing your flat panel
facedown as it may damage the viewing surface.
NOTE: This mount comes with a selection of different screw diameters and lengths to accommodate a wide
variety of flat panel models. Not all of the hardware in the kit will be used.
1. Determine the correct length of the screw to use by examining the back of your flat panel:
A) If the back of your flat panel is flat and the mounting holes are flush with the surface, you will use the
shorter screws (D, F, or H) from the hardware kit.
B) If the back of your flat panel is curved, has a protrusion, or if the mounting holes are recessed, you will
need to use the longer screws (E, G, or I) and may also need to use the spacers (K).
2. Determine the correct diameter of screw to use by carefully trying one of each size (M4, M6, and M8) from
the hardware kit. Do not force any screws. If you feel resistance stop immediately and try a smaller
diameter screw.
3. Insert the tilt adjustment rod so that it passes through both mount arms (see Fig.5). Attach the tilt adjust-
ment knobs (L) using the M4x10 screws (M). Make the tilt adjustment knobs point downwards.
NOTE: If the holes of the mount do not line up with the holes on your flat panel, check to make sure that your
flat panel is VESA compatible. This mount can only be used with flat panels that are VESA 200 x 200
compatible.
4. Remove the clips located near the top of each mount arm and take out the pins. Open both mount arms
completely as shown (Fig. 6).
5. Place the opened mount arms over the back of your flat panel so that the hinges are located toward the
bottom of the flat panel. Slide each mount arm along the length of the tilt adjustment rod until it is lined up
with the mounting holes on the back of your flat panel.
6. Attach the mount arms to the back of your flat panel using the screws identified in steps 1 and 2
(see Fig. 7)
7. Close the mount arms by returning them to the original position. Insert the pin and replace the clip on both
arms. Make sure the tilt adjustment rod is turned to the locked position by rotating the knobs away from
the flat panel. The mount arms must be fully closed and locked before moving on to the next part.
3
All manuals and user guides at all-guides.com
Fig. 5
For flat panels
with flat backs
3
1
2
For flat panels
Fig. 7
with curved or
recessed backs.
Fig. 6
FT2B.ME.062011.IM