Targus amb0301 Mode D'emploi page 24

TARGUS BLUETOOTH® LASER RECHARGEABLE NOTEBOOK MOUSE
Operating Hints
• Avoid using the mouse on a metal surface. Metals, such as
iron, aluminum or copper, shield the radio frequency
transmission and may slow down the mouse response time
or cause the mouse to fail temporarily.
• The mouse will enter a suspend mode at the same time
your computer does. To activate the mouse, press any
mouse button, or simply move the mouse. Please note that
it will take about 2 seconds to wake up.
• If your computer has a metal case that contains aluminum
or magnesium, use the mouse to the side. The display panel
may interfere with the radio frequency signal if you use the
mouse directly in front of the display.
• The best way to tell whether a laser mouse is on and
functioning is by moving the mouse to see if the cursor is
moving. This product will not work until you paired up the
mouse with the bluetooth.
• The scroll wheel will light up (red) for approximately 1 sec.
when the power is turned on.
NOTE: WHILE THE MOUSE IS FUNCTIONING, NO LASER LIGHT IS VISIBLE TO THE
NAKED EYE. BE CAREFUL NOT TO LOOK DIRECTLY INTO THE EMITTER HOLE
WHILE THE MOUSE IS ACTIVE.
Mouse Power Management
• To power the mouse on and off, slide the on/off switch at
the bottom of the mouse to the desired position.
• During the operation, the Power Saving feature allows the
mouse to go into "sleep mode" after 5 minutes of inactivity.
Click any mouse button or move the mouse for about 2
seconds to re-activate the mouse.
• To save battery power, turn off the mouse while traveling or
while not in use.
All manuals and user guides at all-guides.com
24