Worx WX639 Traduction Des Instructions Initiales page 11

allow the machine to cool down by running it
for approx. 3 minutes at maximum speed with
no load.
Grain
Sanding
work
Coarse
sanding
sanding
Sanding
down
180
var-
nishes
Strip-
ping 40
paint
Touch-
ing up
120
paint-
work
Sanding
60
wood
Machin-
ing 180
veneer
Sanding
alumini- 80
um
Derust-
ing 40
metal
Sanding
metal
120
and
steel
Sanding
plexi- 180
glass
3. cycLONIc DUST bOx (See Fig. D)
A) ATTAch ThE cycLONIc DUST bOx
Your sander is equipped with a cyclonic dust
box. To attach, slide the box onto the outlet
piece and take care that the latching lever
engages.
Finishing sander
All manuals and user guides at all-guides.com
Speed
setting
Preci-
(opm)
sion
400 8700~12000
120 9800~12000
120 7600~10000
240 7600~12000
400 8700~11000
240 7600~11000
120 9800~12000
240 9800~12000
400 6500~8700
cAUTION: To prevent the possibility
of sanding dust or foreign body being
thrown into your face or eyes, never attempt
to use your sander without the dust box
properly installed.
b) EmPTy ThE cycLONIc DUST bOx
(See Fig. D1 D2)
For more efficient operation, empty the
cyclonic dust box every 5-10mins. This will
permit the air to flow through the box better.
To empty the box, press the latching lever in
and pull off the box. Then press the button at
the rear of the box to open it, and shake out
dust.
4. USING ThE DUST ExTRAcTION
ADAPTER
Your sander is equipped with an adapter (4)
(See Fig. E), which is designed for connecting
the Cyclonic box. To attach the dust adapter
(11), you need firstly remove the adapter of the
sander (See Fig. F), and then insert the dust
adapter of the cleaner (See Fig. G), afterwards,
you can connect the vacuum cleaner.
If the vacuum hose is 35mm, insert the 35mm
dust adapter (11a) directly into the rear dust
outlet of sander (See Fig. G1).
If the vacuum hose is 32 mm, insert the 32
mm adapter (11b) into the back of 35mm
adapter (11a) (See Fig. G2).
First please turn on the vacuum cleaner, and
then turn on the sander. If you stop sanding,
first turn off the sander, then turn off your
vacuum cleaner.
5 FLUSh SANDING FAcILITy
Your sander can sand flush on three sides of
the base plate which allows easy access to
corners and edges of mouldings.
6 ORbITAL SANDING
Your sander operates in small circular
rotations which allow efficient material
removal. Operate your sander in long
sweeping movements across your work piece
and even across the grain. For a finer finish,
always use a fine grain sanding paper and
only move the sander in the direction of the
grit and never across the grain. Do not allow
your sander to remain in the same position
11
EN