Kohler K-1110 Instructions D'installation page 8

Air Flow Mode
Activates Mode Selected
Rotate Outer Ring to
Access Desired Mode
Power On/Off
Chromatherapy Specific
Color (if provided)
Operating Your Bath with Airjets
Starting the Unit
If the unit does not function properly, please refer to the "Troubleshooting" section.
Close the drain.
Fill the bath to a level at least 2" (5 cm) above the top of the airjets.
Use your hand to test the water temperature for comfort and safety.
Carefully enter the bath basin.
Press the On/Off button on the user keypad.
Observe that the air system starts and air begins to flow to all zones.
Observe that the chromatherapy lights (if provided) also begin operation in the cycling mode.
If desired, adjust the air flow rate using the up button or the down button.
After about 15 seconds, observe that only the last feature selected remains illuminated on the user
keypad.
Selecting Air Flow Modes
Rotate the outer ring to select a desired mode.
Observe that the selected icon is flashing blue.
Press the "OK" button to activate the mode.
Observe that the active mode flashes green and the mode is implemented.
Observe that, after about 15 seconds, the icon stops flashing.
To turn off a mode, rotate the outer ring until the icon is flashing green and then press the "OK"
button again.
The icon will then turn blue indicating the mode is off.
Stopping the Bath
When ready, press the power button a second time to stop the air system.
Carefully exit the bath.
Open the drain to empty the bath.
1038364-5-A
All manuals and user guides at all-guides.com
Zone 1
Rotating Ring Key Pad
Zone 2
Zone 3
Surge Mode
Increase Flow or Surge
Indicator Bar
Decrease Flow or Surge
Chromatherapy Cycle
(if provided)
Purge Mode
8 Kohler Co.