Ergon LS100 Mode D'emploi page 17

ERGON BIKE ERGONOMICS
Instructions for use
1. Some bars are not suitable for use with bar ends or
clamp on grips. If you are unsure, please check for
compatibility with the manufacturer of the handlebar or
your retailer. Ergon recommends that all products are
fitted by qualified professionals. Please take care when
fitting this product.
2. To mount the Plug-In, insert the Plug-In all the way into
the end of the handle-bar, ensuring that the head of the
screw is facing outwards.
3. Loosely tighten the screw while preventing the Plug-In
from turning by holding it as pictured. (fig 1)
4. Using a torque wrench tighten the Plug-In to no more
than 4 Nm. Be especially careful when using the
Plug-In in combination with a carbon handlebar not to
exceed this torque. Do not over tighten.
17