GreenWorks CRD401 Manuel De L'utilisateur page 8

EN
SYM- SIGNAL
BOL
DANGER
WARNING
CAUTION
CAUTION
8 PROPOSITION 65
This product contains a chemical known to the
state of California to cause cancer, birth defects
or other reproductive harm. Some dust created by
power sanding, sawing, grinding, drilling, and other
construction activities contains chemicals known to
cause cancer, birth defects or other reproductive
harm. Some examples of these chemicals are:
• Lead from lead-based paints;
• Crystalline silica from bricks and cement and other
masonry products;
• Arsenic and chromium from chemically treated
lumber.
Your risk of exposure to these chemicals varies
depending on how often you do this type of work. To
reduce your exposure to these chemicals, work in a
well-ventilated area, and work with approved safety
equipment, such as dust masks that are specially
designed to filter out microscopic particles.
Save these instructions.
9 INSTALLATION
9.1 UNPACK THE MACHINE
Make sure that you correctly assemble the machine
before use.
MEANING
Indicates an imminently
hazardous situation, which,
if not avoided, will result in
death or serious injury.
Indicates a potentially haz-
ardous situation, which, if
not avoided, could result in
death or serious injury.
Indicates a potentially haz-
ardous situation, which, if
not avoided, may result in
minor or moderate injury.
(Without Safety Alert Sym-
bol) Indicates a situation
that may result in property
damage.
WARNING
WARNING
English
• If parts of the machine are damaged, do not use
the machine.
• If you do not have all the parts, do not operate the
machine.
• If parts are damaged or missing, contact the
service center.
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance
with local regulations.
9.2 INSTALL THE BLADE
Before you install the blade, remove the battery pack
from the machine.
1. Use the lower guard lever to lift the lower guard and
hold the lever.
2. Install the new blade.
3. Put the outer flange and the blade bolt on the
spindle.
4. Push the spindle lock button to lock the spindle.
5. Use the hex key to tighten the bolt clockwise.
The arrow on the blade points the same direction as
the arrow on the top guard.
8
WARNING
1
2
3
3
NOTE
NOTE