GreenWorks CRD401 Manuel De L'utilisateur page 10

EN
10.4 CUTTING DEPTH
1. Loosen the depth adjustment knob.
2. Raise or lower the base until the depth scale
reaches the required cutting depth.
3. Tighten the depth adjustment knob.
10.5 CUTTING WIDTH
1. Loosen the width adjustment knob to move the edge
guide to the necessary width.
2. Tighten the width adjustment knob after adjustment.
10.6 OPERATE THE MACHINE
English
@ 90°
@ 0°
10
Kickback occurs when the blade stalls quickly and the
machine is driven back to you. A step which pinches the
blade in the wood can cause blade stalling.
WARNING
To prevent kickback, release switch trigger
immediately if the blade stalls.
1. Keep the blade at the correct depth position.
2. Examine the workpiece for nails before you cut. Do
not saw into a nail.
3. Make straight cuts. Use a straight edge guide when
rip cutting. This helps prevent you twist the blade.
4. Use clean, sharp, and correctly set blades. Do not
make cuts with blunt blades.
5. Support the workpiece correctly before you begin a
cut.
6. Use stable pressure when you make a cut. Do not
force a cut.
7. Do not cut warped or wet lumber.
8. Hold the saw tightly with the two hands and keep
your body in a balanced position to against the
forces if kickback occurs.
11 MAINTENANCE
CAUTION
Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can
cause damage to the plastic, and make the plastic
unserviceable.
CAUTION
Do not use strong solvents or detergents on the plastic
housing or components.
WARNING
Remove the battery pack from the machine before
maintenance.