ZANKER KHP90265XA Notice D'utilisation page 23

Cleaning the grease filter
Filters are mounted with the use of clips and pins on the
opposite side.
To clean the filter:
1. Press the handle of the mounting clip on the filter
panel underneath the hood.
1
2
2. Slightly tilt the front of the filter downwards, then
pull.
Repeat the first two steps for all filters.
3. Clean the filters using a sponge with non abrasive
detergents or in a dishwasher.
The dishwasher must be set to a low
temperature and a short cycle. The
grease filter may discolour, it has no
influence on the performance of the
appliance.
4. To mount the filters back follow the first two steps in
reverse order.
Repeat the steps for all filters if applicable.
Environmental concerns
Recycle materials with the symbol
packaging in relevant containers to recycle it. Help
protect the environment and human health by recycling
waste of electrical and electronic appliances. Do not
. Put the
Replacing the charcoal filter - optional
Warning! Depending on type, filter can
be or cannot be regenerated. Refer to
the leaflet provided with the filter.
To replace the filter:
1. Remove the grease filters from the appliance.
Refer to "Cleaning the grease filter" in this chapter.
2. Pull the tabs towards the bottom part of the filter.
3. Slightly tilt the front of the filter downwards, then
pull.
4. To install a new filter, perform the same steps in
reverse order.
In any case, it is necessary to replace the filters at least
every four months.
Replacing the lamp
This appliance is supplied with a LED lamp. This part
can be replaced by a technician only. In case of any
malfunction refer to "Service" in the "Safety Instructions"
chapter.
dispose of appliances marked with the symbol
the household waste. Return the product to your local
recycling facility or contact your municipal office.
with
23