Giant Momentum Mode D'emploi page 11

All manuals and user guides at all-guides.com
3.2.5 Usage
The bike will draw power from the battery when it is
switched on. If only 3% of the EnergyPak power is
left, the EnergyPak will automatically switch assis-
tance to ECO mode in order to save energy.
If only 1% of the EnergyPak power is left, assistance
will automatically stop. Power assist level indication
bar will blink 3 times. Lights can still be used for
over 2 hours.
Power in the EnergyPak can be checked by push-
ing the Energy Level check button.
The EnergyPak should be used at temperatures
between 0°C and 40°C (32°F and 104°F). Using
the EnergyPak at higher or lower temperatures can
negatively influence the range or could result in unexpected errors. Prolonged use during very high or
low temperatures can be harmful to the battery life cycle.
After 15 normal charges, or at least every 3 months, discharge the EnergyPak completely by
riding the bicycle before charging the EnergyPak again. This will increase the lifespan of the
EnergyPak.
When an EnergyPak is connected to the bike, some small amount of power will get lost in the system
when the bike is not in use. To prevent this, the EnergyPak can be disconnected from the bike when not
in use for more than a few days.
3.2.6 Storage
If the bike is not used for a longer period (one month or more) the EnergyPak is best stored:
• At 60% of its capacity. For 'smart charger', that is a functionality.
• Separate from the bike.
• At temperatures between 0°C and 40°C (32°F and 104°F).
• Checked every month to see if at least one LED is still blinking. Charge when needed.
Charging the EnergyPak should be done at a minimum of every 3 months. Negligence to this could void
the warranty of the EnergyPak.
7