Inventum AC170 Mode D'emploi page 8

2
appliance description
1. Spout
2. Anti-scale filter
3. Lid
4. Lid opening knob
5. Handle
6. Water level indicator
7. On/ off switch with pilot lamp
8. Power base
3
prior to first use
Follow these instructions when using the kettle for the first time: Carefully remove the kettle from the packaging and remove all
packaging material. Keep the packaging (plastic bags and cardboard) out of the reach of children. After unpacking the appliance,
check it for external damage that may have occurred during transport. Place the kettle on a heat-resistant flat surface.
The minimum water filling volume is 0.5 litres. The maximum filling volume is 1.7 litres.
Prior to use, the appliance must be filled to the maximum twice and the water must be brought to the boil twice. Throw away the
boiled water and rinse the appliance with cold water. The appliance is now ready for use.
The kettle is only suitable for boiling water. Never fill the kettle with milk, tea, coffee or other instant drinks.
4
boiling water
Check that the voltage stated on the information plate matches the voltage used in your region.
Place the connection base on a flat, stable surface. Insert the plug in an earthed wall socket. Place the kettle on the base.
If necessary, excess cord can be stored in the bottom of the connection base by rolling up the cord.
1. Open the lid by pressing the button.
2. Fill the kettle with the required volume of water and close the lid by pressing it close.
3. Place the kettle on the connection base and make sure the plug is in the socket.
4. Switch on the kettle by pressing down the on/off switch at position 1. The pilot lamp lights up. The kettle starts to boil the water.
5. The kettle switches off automatically when the water boils.
The pilot lamp switches off.
Caution: never switch on the kettle when it contains no water. If, by accident, the kettle is switched on without water in it, the
boil dry safeguard switches off the kettle automatically. In this case, remove the kettle from the connection base and allow it
to cool down for a few minutes. Then you can fill the kettle with water and switch it on again. Check that the lid of the kettle is
properly closed. If not, the kettle does not switch off automatically when the water boils and continues to boil.
8
• English
All manuals and user guides at all-guides.com
2
1
3
4
5
6
7
8
8