Worx WX640.1 Mode D'emploi page 10

2. DUST bOx (See Fig. C, D)
a) aTTaCH THE DUST bOx (See Fig. C)
Your sander is equipped with a dust collection
box. To attach, slide the dust box onto the
outlet piece and take care that the dust box
locks in the grooves of the outlet.
CaUTION: To prevent the possibility
of sanding dust or foreign body being
thrown into your face or eyes, never attempt
to use your sander without the dust box
properly installed.
b) EMPTY DUST bOx (See Fig. D)
For more efficient operation, empty dusts box
every 5-10mins. This will permit the air to flow
through the box better. To empty the dust box,
pull off the dust box out of the dust extraction
outlet directly and shake out dust.
3. USINg THE DUST ExTRaCTION
aDaPTER (See Fig E, F)
Your sander is equipped with two dust
extraction adapters, which are designed for
connecting the hose of a vacuum cleaner.
If the vacuum hose is 35mm, insert the 35mm
dust adapter (a) directly into the rear dust
10
outlet of sander (See Fig. E).
If the vacuum hose is 32 mm, insert the 32
mm adapter (b) into the back of 35mm adapter
(a) (See Fig. F).
NOTE: Please pull the dust adapter to make
sure tightened securely on the dust outlet.
4. FLUSH SaNDINg FaCILITY
Your sander can sand flush on three sides of
the base plate which allows easy access to
corners and edges of mouldings.
5. ORbITaL SaNDINg
Your sander operates in small circular
rotations which allow efficient material
removal. Operate your sander in long
sweeping movements across your work piece
and even across the grain. For a finer finish,
always use a fine grain sanding paper and
only move the sander in the direction of the
grit and never across the grain. Do not allow
your sander to remain in the same position
otherwise you will remove material and create
an uneven surface.
Finishing sander
All manuals and user guides at all-guides.com
WORKING HINTS FOR YOUR
FINISHING SANDER
If your power tool becomes too hot, especially
when used at low speed, set the speed to
maximum and run it with no load for 2-3
minutes to cool the motor. Avoid prolonged
usage at very low speeds. Always use sand
paper that is suitable for the material you want
to sand.
Always ensure the work-piece is firmly held or
clamped to prevent movement.
Any movement of the material may affect the
quality of the sanding finish.
Start your sander before sanding and turn it
off only after you stop sanding. For the best
results, sand wood in the direction of the
grain.
Do not start sanding without having the
sandpaper fitted.
Do not allow the sandpaper to wear away it
will damage the base-plate. The guarantee
does not cover base-plate wear and tear.
Use coarse grit paper to sand rough surfaces,
medium grit for smooth surfaces and fine grit
for the final surfaces. If necessary, first make a
test run on scrap material.
Use only good quality sandpaper.
The sandpaper controls the sanding efficiency,
not the amount of force you apply to the
tool. Excessive force will reduce the sanding
efficiency and cause motor overload.
Replacing the sandpaper regularly will
maintain optimum sanding efficiency.
MAINTENANCE
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional
lubrication or maintenance. There are no
user serviceable parts in your power tool.
Never use water or chemical cleaners to
clean your power tool. Wipe clean with a
dry cloth. Always store your power tool in a
dry place. Keep the motor ventilation slots
clean. Keep all working controls free of dust.
Occasionally you may see sparks through the
ventilation slots. This is normal. If the supply
EN