Spark Plug; Disposal And Recycling; Ordering Replacement Parts - EINHELL BT-PG 750 Mode D'emploi D'origine

Anleitung_BT_PG_750_SPK1:_
service information.
Remove the air filter cover (Figs. 7-8/Item 5).
Remove the air filter (Fig. 9/Item G).
Clean the air filter by tapping it. In cases of
stubborn dirt first clean with soapy water, then
rinse with clear water and air-dry before
reinserting. Important: Do not use abrasive
cleaners or petrol to clean the air filter.
Assemble in reverse order

7.3 Spark plug

Check the spark plug for wear at regular intervals. In
this connection, please also read the service
information.
Remove the spark plug cover.
Pull off the spark plug boot (Fig. 5/Item I) by
twisting it.
Remove the spark plug (Fig. 6/Item J) using the
supplied spark plug wrench.
Clean the spark plug with a copper wire brush or
fit a new one.
Assemble in reverse order.
7.4 Storage
1. Empty the petrol tank using a petrol suction
pump.
Important: Do not empty the petrol tank in
enclosed areas, near fire or when smoking.
Petrol fumes can cause explosions and fire.
2. Start the engine and run it until the tank and fuel
line are completely empty and the engine stalls.
3. Let the unit cool down.
4. Remove the spark plug and pour approx. 20 ml
of engine oil into the cylinder.
5. Pull the starter handle slowly several times to
coat the internal parts.
6. Screw the spark plug back in.
7. Store the unit in a well-ventilated, safe place.
Important: Always transport the unit in the upright
position (even when the tank breather hole is
closed).

7.5 Ordering replacement parts:

Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
05.10.2011 16:58 Uhr Seite 13

8. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.
GB
13