Publicité
Les langues disponibles
Les langues disponibles
Powerbar with Surge Protection (recommended)
Most electrical appliances use a series of electric control boards to operate. These boards are
very susceptible to power surges and could be damaged or destroyed.
If the appliance is going to be used in an area or if your city / country is prone to power surges /
outages; it is suggested that you use a power surge protector for all electrical devices / appliances
you use. The surge protector that you select must have a surge block high enough to protect the
appliance it is connected to. If you have any questions regarding the type and size of surge
protector needed contact a licensed electrician in your area.
Installing the Handle
This wine cellar includes a stainless-steel handle. To install the handle please follow the below
instructions:
1. Remove the door gasket where the handle should be installed on the left side of the door,
as shown below. You won't need tool since the gasket can be removed by hand. You can
start with a corner if you can't remove it from the center.
2. Use the two handle screws, lock washer and flat washer included in the bag containing the
instruction manual and insert them into the side of the door from the inside to the outside.
3. Align the holes in the handle with the screws, tighten the screws using the screwdriver until
the base of the handle is at the level of the door and that the handle is tight but not too
tight to damage the assembly.
4. Replace the gasket the door in place.
1. Gasket
2. Flat washer
3. Lock washer
4. Screw
5. Handle
6. Door frame
25
Publicité
