Publicité
Les langues disponibles
Les langues disponibles
a WARNING: Always stop the power tool and disconnect the power cord before performing any of the
recommended remedies below.
Starting and running problems
Trouble
Trimmer fails to operate
Trimmer operates intermittently
Trimmer line problems
Trouble
• Trimmer line not feeding
• Trimmer line too short
• Trimmer vibrates
Continuous clattering noise
Trimmer line snaps continuously
Rated voltage
Rated power
Cutting diameter
Trimmer line diameter
Unloaded speed
Weight
Protection class
591048301 Spool and trimmer line complete
Environmental protection
• Waste electrical products should not be disposed of with household waste.
• Please recycle where facilities exist.
• Check with your local authority or retailer for recycling advice.
All manuals and user guides at all-guides.com
TROUBLESHOOTING
Cause
1.
No power
2.
Faulty wall outlet
3.
Extension cord damaged
4.
Circuit breaker shut off or faulty
1.
Extension cord damaged
2.
Loose internal connection
3.
Internal wiring defective
4.
Trigger defective
Cause
Automatic trimmer line feed not working
Trimmer line not visible
Manual trimmer line feed not working
Motor not reaching full speed before use
Too much trimmer line fed out
Trimmer line cutter missing
Incorrect trimming technique
TECHNICAL DATA
SERVICE PARTS
Remedy
1.
Check power
2.
Use another outlet
3.
Check cord, replace
4.
Reset or replace circuit breaker
1.
Check cord, replace
2.
Call an authorized service center
3.
Call an authorized service center
4.
Call an authorized service center
Remedy
Manually feed out trimmer line
Remove spool cap and spool, free trimmer line
and re-install spool and spool cap.
Rewind trimmer line to remove crossed loops.
Check that trimmer line is in correct section of
spool.
Allow the motor to reach full speed before use
Rewind trimmer line
Replace trimmer line cutter
Only use tip of trimmer line to trim
WE14T
120V~60Hz
600 W
36 cm (14 in)
Ø1.6 mm (0.065 in)
-1
11,280-12,720 min
4.3 kg (9.5 lb)
/ II
(RPM)
9
Publicité
