Télécharger Imprimer la page

Egret X+ Consignes D'utilisation page 37

Publicité

Les langues disponibles

Les langues disponibles

Warning and safety information
Any alterations, technical or visual modifications or changes to the electronics or software
may instantly invalidate the operating approval, the warranty and other claims against the
manufacturer, and may pose a significant risk to life and health. Changes to the vehicle may
lead to injuries, electric shock or accidents.
The Egret electric scooter is approved exclusively to carry one person and a maximum load
of 120 kg in total. Overloading the scooter will impair the driving performance and may
cause serious falls and accidents. The increased stresses on the material may also cause
greater wear and may lead to premature material fatigue.
After the first 50 km, check again that all screw connections are secure, particularly on the
folding mechanism and wheel axles, and tighten them if necessary. Loose screw connections
may lead to functional failure and serious accidents.
Do not ride the scooter in rain or snow or on wet or slippery surfaces. The Egret electric
scooter is protected against splashes but these surfaces require longer braking distances.
This may lead to falls, accidents and injuries. If you cannot avoid a ride in bad weather, adapt
your riding behaviour to the conditions and allow for longer braking distances, for example.
Only use the supplied accessories, genuine spare parts and the original power supply unit,
and only use these if they are in the correct technical condition. Damaged cables or other
components must be replaced immediately. Faulty or non-genuine components may lead to
electric shocks, fire, component failure and accidents.
Never ride the scooter with an open safety lever or open safety lock on the folding mecha-
nism. If the folding mechanism if not locked correctly, the Egret electric scooter may fold up
during travel and there is a risk of falls.
Never ride without holding the handlebars. This causes unstable riding and may lead to
accidents and injuries.
Before performing any maintenance or cleaning work on the Egret electric scooter, the
scooter must be switched off and disconnected from the power supply unit. If it is not swit-
ched off and disconnected, there is a risk of electric shock.
Never direct a strong jet of water (e.g. pressure washer) at the Egret electric scooter.
This may cause water to enter the components and damage the electronics. Water in
the battery compartment may lead to electric shock.
37

Publicité

loading

Produits Connexes pour Egret X+