Télécharger Imprimer la page

IKEA TYNNERAS Mode D'emploi page 5

Masquer les pouces Voir aussi pour TYNNERAS:

Publicité

Les langues disponibles

Les langues disponibles

ENGLISH
1.5 Installation Safety
To prepare the product for installation, see the
information in the user guide and make sure
the electric and water utilities are as required.
If the installation is not suitable, call a qualified
electrician and plumber to have them make the
necessary arrangements. Otherwise, electric
shock, fire, issues with the product or injuries may
occur.
Check for any damage on the product before
installing it. Do not have the product installed if it
is damaged.
Place the product on a level and hard surface and
balance with the adjustable legs. Otherwise, the
refrigerator may tip over and cause injuries.
The product shall be installed in a dry and
ventilated environment. Do not keep carpets, rugs
or similar floor covers under the product if it is not
recommended by the supplier.This may cause risk
of fire as a result of inadequate ventilation!
Do not block or cover ventilation holes. Otherwise,
power consumption may be increased and
damage to your product may occur.
Do not connect the product to supply systems
such as solar power supplies. Otherwise, damage
to your product may occur as a result of the
abrupt voltage fluctuations!
The more refrigerant a refrigerator contains, the
bigger its installation room shall be. In very small
rooms, a flammable gas-air mixture may occur
in case of a gas leak in the cooling system. At
least 1 m³ of volume is required for each 8 grams
of refrigerant. The amount of the refrigerant
available in your product is specified in the Type
Label.
The installation place of the product shall not be
exposed to direct sunlight and it shall not be in the
vicinity of a heat source such as stoves, radiators,
etc.
If you cannot prevent installation of the product in
the vicinity of a heat source, you shall use a suitable
insulation plate and the minimum distance to the heat
source shall be as specified below.
- At least 30 cm away from heat sources such as stoves,
heating units and heaters, etc.,
- And at least 5 cm away from electric ovens.
Your product has the protection class of I. Plug
the product in a grounded socket that conforms
with the Voltage, Current and Frequency values
specified in the type label. The socket outlet shall
be equipped with a fuse with a rating of 10 A – 16
A. Our company shall not be responsible for the
damages that shall be incurred as a result of
operating the product without ensuring ground
and electrical connections made as per local or
national regulations.
The product's power cable must be unplugged
during installation. Otherwise, risk of electric
shock and injury may occur!
Do not plug the product to loose, broken, dirty,
greasy sockets or sockets that has come out their
seats or sockets with a risk of water contact.
Place the power cord and hoses (if available) of
the product so that they shall not cause a risk of
tripping over.
Penetration of humidity to live parts or to the
power cord may cause short circuit. Thus, do not
use the product in humid environments or in areas
where water may splash (e.g. garage, laundry
room, etc.) If the refrigerator is wet by water,
unplug it and contact an authorized service.
Do not connect your refrigerator to power saving
devices. These systems are harmful for the
product.
1.6 Operational safety
Do not use chemical solvents on the product.
These materials contain an explosion risk.
In case of a failure of the product, unplug it and do
not operate until it is repaired by the authorized
service. There is a risk of electric shock!
Do not place a source of flame (e.g. candles,
cigarettes, etc.) on the product or in the vicinity
of it.
Do not get on the product. Risk of falling and
injury!
Do not cause damage to the pipes of the cooling
system using sharp and piercing tools. The
refrigerant that sprays out in case of puncturing
the gas pipes, pipe extensions or upper surface
coatings may cause irritation of skin and injuries
of the eyes.
Do not place and operate electric appliances inside
the refrigerators/deep freezer unless it is advised
by the manufacturer.
Do not jam any parts of your hands or your body
to the moving parts inside the product. Be careful
to prevent jamming of your fingers between the
refrigerator and its door. Be careful while opening
or closing the door if there are children around.
Do not put ice cream, ice cubes or frozen food to
your mouth as soon as you take them out of the
freezer. Risk of frostbite!
Do not touch the inner walls, metal parts of the
freezer or food kept inside the refrigerator with
wet hands. Risk of frostbite!
Do not place soda cans or cans and bottles that
contain fluids that may be frozen to the freezer
compartment. Cans or bottles may explode. Risk
of injury and material damage!
Do not use or place materials sensitive against
temperature such as flammable sprays, flammable
objects, dry ice or other chemical agents in
the vicinity of the refrigerator. Risk of fire and
explosion!
Do not store explosive materials such as aerosol
cans with flammable materials inside the product.
Do not place cans containing fluids over the
product. Splashing of water on an electrical part
may cause the risk of an electric shock or a fire.
This product is not intended for storage and
cooling of medicines, blood plasma, laboratory
preparations or similar materials and products
that are subject to the Medical Products Directive.
If the product is used against its intended purpose,
it may cause damage to or deterioration of the
products kept inside.
If your refrigerator is equipped with blue light,
do not look at this light with optical devices. Do
not stare directly at UV LED light for a long time.
Ultraviolet rays may cause eye strain.
Do not fill the product with more food than its
capacity. Injuries or damages may occur if the
contents of the refrigerator falls when the door
5

Publicité

loading