Balancing The Arm; Electrical Connections - Bft Maxima Ultra 68 Instructions D'utilisation Et D'installation

EN
Give the "START" command to position
the arm holder vertically

2.6 BALANCING THE ARM

Put the bar
in a vertical position.
2.7 OPTIONALS
2. Installation
Opening
microswitch cam
3 mm
TO SET THE BOOM IN VERTICAL
POSITION ADJUST THE OPEN LIMIT
SWITCH CAM.
19mm
For the "A" value see
TAB.1 page 34
ADDITIONAL
LIMIT SWITCH

2.8 ELECTRICAL CONNECTIONS

CSB-Xtreme
Consult the control unit's installation
and operating manual
- 14 -
Check that the bar is
in vertical position
45°
Check that the arm is
balanced at ~45°