Switch Stimulation Mode / Expression Mode; Sensitive Programme; Time Button; Backlight Button - Ardo CARUM Mode D'emploi

en

4.3.4. Switch stimulation mode / expression mode

To change the stimulation mode display screen (orange display) to the
expression mode display screen (green display), press the mode button
just to the right of the stand-by button.
The change can be made at any time by pressing the mode button.
If the Carum is in stimulation mode and the mode button is not pressed,
the unit will automatically change to expression mode after 2 minutes.
Press the mode button to return to stimulation mode.
When the mode changes, the background colour of the LCD screen
changes accordingly. In addition, the symbol relevant to stimulation or
expression mode will be highlighted on the LCD display.
Background colour in stimulation mode is orange.
Background colour in expression mode is green.
In each separate mode of operation, vacuum strength and cycles level can
be individually adjusted.

4.3.5. "Sensitive Programme"

The "Sensitive Programme" pumps with
a barely noticeable vacuum and deep
cycle; thus, expression with the "Sensitive
Programme" is particularly suitable for sore
nipples. Here vacuum and cycles can be
gently increased.
Procedure:
1. Press stand-by button.
2. Press the mode button while the welcome screen appears.

4.3.6. Time button

Timing starts automatically when the Carum is switched on. To stop
timing, press the time button. Timing will remain de-activated until re-
started by pressing the time button again, or until the unit is turned off.
The timer will be reset to 00:00 when the time button is pressed for a
second time.
Press the time button again to restart the timer. The timer can be
switched on and off in either stimulation or expression mode.

4.3.7. Backlight button

Using the Carum in a darkened room can be made more comfortable
by dimming the intensity of the LCD. To reduce the intensity of the
backlighting, press the backlight button (to the left of the LDC) once.
The dim function can be turned on and off as required.

4.3.8. Carum Battery

The battery level is shown on the display. The battery charging time to
the power supply is approximately four hours. The pump can be used
while the battery is being charged. This will extend the charging time. The
battery can be charged at any time without reducing the lifetime of the
battery.
10
CARUM
00:00
Vacuum Cycles
CARUM
00:00
Vacuum Cycles
CARUM
00:00
Vacuum Cycles
CARUM
02:00
Vacuum Cycles
CARUM
02:00
Vacuum Cycles
CARUM
BAT TERY
00:00
Vacuum Cycles