Publicité
Les langues disponibles
Les langues disponibles
To ensure proper engine operation, the spark plug should
be clean and with adequate gap between the electrodes.
There are several factors that can affect the operation of the
spark plug: incorrect carburetor adjustment and fuel, and
dirty air filter. These factors cause particles accumulations
in the spark plug electrodes, which leads to operating
problems and difficult start-ups.
If the lawnmower is running low or shows difficulties in
starting, check the spark plug condition before making any
further inspections.
1. Remove the spark plug cap, unscrew the spark plug and
check that it is clean. If dirty, clean the soot with a brush;
2. If the spark plug is "wet", with excess fuel, place a clean
cloth over the spark plug hole and pull the recoil starter
several times without the spark plug installed;
3. Measure the distance between the electrodes with
appropriate tools. The distance should be between 0.7-
0.8 mm. If necessary, bend the electrode until enough
clearance is reached;
4. Install the spark plug with your hand to prevent damage
to the thread and tighten it to compress the sealing
washer, using the wrench provided;
5. If the spark plug does not produce any sparks, replace
it.
A loose spark plug may overheat and cause damage
to the engine.
Always use the type of spark plug recommended by
the manufacturer. The use of an incorrect spark plug
can damage the cylinder.
Storage
Preparing storage for long periods is vital to avoid problems
and increase the useful life of the lawnmower.
Never store the equipment with petrol in the tank.
Depending on the region and storage conditions, petrol can
deteriorate and oxidize, causing damages in the carburetor
and fuel system, difficult starts and clogging caused by
particle accumulation.
Before storage proceed as follows:
1. Empty the fuel tank;
2. Start the engine until it stops due to lack of fuel;
3. Remove the spark plug and add 2-stroke engine oil (5-
10 cl) to the cylinder through the spark plug hole;
4. Place a clean cloth over the spark plug hole and pull the
starter handle to dispense the oil to the cylinder;
5. Pull the recoil starter slowly while feeling some
resistance. The piston rises and the intake and exhaust
valves are closed. Leaving the engine in this position will
help protect against internal corrosion;
6. Reinstall the spark plug.
Cleaning
The lawnmower must be thoroughly cleaned after each use.
Remove any waste accumulated in the blade. Careful
handling protects the equipment and extends its service
life.
The packaging is made up of recyclable materials,
which you can dispose on local recycling points.
Never dispose of combustion equipment in your
household waste!
Waste such as used oil, fuel, lubricant, filters and wearing
parts can harm humans, animals and the environment and
as such must be properly disposed of.
Make sure that the deactivated equipment is forwarded for
disposal in a technically correct way.
Tel.:
+351 256 248 826
E-mail:
international@centrallobao.pt
Website:
www.centrallobao.pt
Publicité
