Thermador An American Icon Professional PRO-GRAND PRD30 Manuel D'installation page 9

Gas and Electric Supply Zone
Note:
If not already present, install gas shut-off valve in an easily
accessible location. Make sure all users know where and
how to shut off the gas supply to the range.
Note:
The installer should inform the consumer of the location of
the gas shut-off valve.
Note:
Any opening in the wall behind the appliance and any
opening in the floor under the appliance must be sealed.
The dual fuel ranges may be connected to the power
supply with a range supply cord kit or by hard-wiring to the
power supply. It is the responsibility of the installer to
provide the proper wiring components (cord or conduit and
wires) and complete the electrical connection as dictated
by local codes and ordinances, and/or the National Electric
Gas & Electrical
Supply Zone
7-1/4"
A B
30" (30" models)
36" (36" models)
48" (48" models)
Model A
30" 7-1/2"
36" 10-7/8"
48" 17-1/8"
Figure 3a: Gas & Electrical Supply Locations for Dual Fuel Ranges
2" maximum protrusion
from wall for gas or
electrical supply
2"
C
B C
15-1/8" 7-3/8"
14-3/8" 10-3/4"
15-3/8" 15-1/2"
Code. The units must be properly grounded. Refer to Step
6 for details.
The range must be connected only to the type of gas
for which it is certified. If the range is to be connected to
propane gas, ensure that the propane gas supply tank is
equipped with its own high pressure regulator in addition to
the pressure regulator supplied with the range. (See
Step 5.)
Note:
The range is designed for nearly-flush installation to the
back wall. For a successful installation, it may be
necessary to reposition the gas-supply line and electrical
cord as the range is pushed back to its final position.
SUGGESTION: This may be accomplished by carefully
pulling on a rope or twine looped around the gas or
electrical supply line as the range is pushed back into
its final installed position.
English 7