hajdu HP-TOWER HPT200 Manuel De Mise En Service, D'opération Et D'entretien page 64

HPT 200 • HPT 200C
WARNING
Due to potential danger, please keep packaging materials (clips, plastic sacks, polys-
tyrene foam etc.) away from children.
During handling or transportation of the appliance after its first start up, please, ob-
serve the warnings about the maximum tilting angle above and ensure that all wa-
ter has been discharged from the tank. If you do not have the original packaging any
more, please, provide protection to the appliance and its parts similar to the original
packaging.
2. TECHNOLOGICAL CHARACTERISTICS
2.1. Construction features
The HPT200(C) heat pump boiler is basically composed of an upper part (Figure 2.1.-1.)
containing the heat pump unit and a lower part (Figure 2.1.-2.) containing the storage
tank. The storage tank of sanitary hot water – having a volume of (300 l) – is covered by
an enamel coating internally and by a highly efficient thick polyurethane insulation layer
externally, where the latter is covered by the metal surface of the appliance. The pipe
radiator, limiter, anode indicator electronic unit and magnesium indicator anode are lo-
cated inside the heater. The condensate water discharge pipe branch is located in the
rear part of the above circular tray. The control panel with a display is located in the
front part. All the other parts of the heat pump circuit are located above the storage
tank in a precisely designed order that enables optimal operation, and reduced vibra-
tion and noise emission.
Figure 2.1.-1
12