CF MOTO 450SS 2023 Guide De L'utilisateur page 114

TIRES & CHAINS
Chain tension inspection
Shift the gear into Neutral;
Park with the side stand;
Push up the chain to inspect its tension;
If the chain tension is not in line with relevant specifications,
then adjust it to the standard�
Standard value: 0.98in~1.38in (25 mm ~ 35 mm).
25 mm ~ 35 mm
NOTE:
The wear of the chain is not always uniform, and the tension
should be repeatedly measured by rotating the rear wheel
several times in different positions�
Drive Chain Tension Adjustment
2
Loosen the rear wheel shaft nut ;
1
Loosen the left and right locking nuts ;
2
1
Screw the left and right adjusting bolts to adjust the chain
3
tension, ensuring the alignment marks on the left and right chain
tensioners are the same with the reference mark position;
Tighten the left and right locking nuts;
3
Tighten the rear wheel shaft nut(105N•m~110N•m)�
114