Technical Data; Installation Diagram - Beta 680/2,5 Mode D'emploi

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO

TECHNICAL DATA

NOMINAL POWER SUPPLY VOLTAGE
POWER SUPPLY OUTPUT VOLTAGE
ABSORPTION
DISPLAY
TORQUE MEASURING RANGE
ACCURACY
RESOLUTION
HEXAGON MALE DRIVE
DIMENSIONS
SELECTABLE UNITS OF MEASUREMENT
OPERATING TEMPERATURE
STORAGE TEMPERATURE
WEIGHT
KEY TO SYMBOLS
a: digital display
b: unit of measurement
c: mode selection
d: hexagon male drive 1/4"

INSTALLATION DIAGRAM

INSTALLATION
Identify a suitable surface and position to install the instrument.
Mark the positions of the two mounting holes as shown in the installation diagram.
Drill (and tap, if need be) the two mounting holes (we recommended using a cheese-headed screw
Dynatester when the maximum permissible torque is applied.
The Dynatester is now ready for use.
OPERATION
Press and hold the MODE button to change the mode of operation. Release the button at the required
mode to accept.
MODES OF OPERATION:
• Track Mode (TRAC is displayed): the display reads the torque being applied.
data output of peak torque is automatically transmitted. The display automatically resets after
3 seconds. For use with click type torque wrenches.
• Dial Mode (DIAL is displayed): the display shows the peak of torque being applied. Press RESET
to clear the display. For use with analogue and electronic torque wrenches.
Press UNIT to change the unit of measurement.
9V CC
1.8 W max
4 digits
± 1%
0.1°
1/4"
N.m, lbf.ft, lbf.in
EN I
9