SCHOTT KL 2500 LCD Conseils D'utilisation page 18

2.5 Filter wheel
The KL 2500 LCD has a filter wheel (7)
which can be fitted with a maximum
of 5 filters.
Different color and fluorescence
excitation filters (available as accesso-
ries) can be brought into the optical
path by turning the ridged edge of the
filter wheel.
Please ensure that the filter wheel is
always engaged in one of the predefined
rest positions.
Operating the light source with the
filter wheel in an intermediate position
can cause the wheel to overheat.
The ridged edge of the filter wheel has
position markings (the corresponding
number of raised marks identifies posi-
tions 0 to 4).
17
All manuals and user guides at all-guides.com
2.5.1 Fitting the Filter
Please ensure the light care to ensure
that the light source is switched off and
has cooled down before removing the
filter wheel.
There is a warning symbol
remind you.
To remove the filter wheel, take hold in
the depression on the underside of the
carrier, pull it out to the stop, lift slightly
and then carefully remove.
To fit filters into the wheel, remove
the cross-head screw and remove the
plate holding the filter in place.
Insert the filter into the wheel. Push on
the plate and tighten the screw. Insert
the filter wheel into the guide and push
it into the cold light source until it
engages.
Please ensure that your KL 2500 LCD
is operated exclusively with the existing
filter wheel. This is the only way to
guarantee optimum air cooling of the
light source.
2.6 Remote control connection
A remote control and/or inclination
angle switch (accessories) can be
connected to the light source via the
connection socket (8).
to
The indication "REMOTE" (22) appears
in the LCD display when the remote
control is plugged in.
The remote control can electronically
set the light intensity, thus putting the
light intensity control knob (3) tem-
porarily out of operation.
Both the remote control and the
inclination angle switch provide a
facility to put the light source into
"STAND-BY" mode to protect the
halogen lamp. A corresponding indi-
cation (21) appears in the display.
Please note the following:
In "STAND-BY" mode the appliance is
not disconnected from the mains elec-
tricity supply. The remote control (or
the inclination angle switch) should
only be connected and disconnected
when the appliance is switched off.