Publicité
Les langues disponibles
Les langues disponibles
Gain Controls
The Gain controls are recessed and can be adjusted
with a small screwdriver or flat tool. If desired, the Gain
Control Security Cover can be installed to prevent
changes to the installer's settings.
Turn the gain controls clockwise to increase gain and
counter clockwise to decrease gain. The maximum volt-
age gain of the amplifier varies depending on the model
designation. Maximum voltage gain for each model is
shown on the front panel label in parentheses adjacent
the 0dB attenuation setting.
The Gain controls are marked in dB of attenuation.
There are 21 detents for repeatable adjustments. The
upper 14 steps are about 1 dB each, and settings
should normally be made within this range. The range
below -14 dB should not be used for normal program
levels, as the input headroom could be exceeded, but
can be used for testing at reduced levels. At the mini-
mum setting, the signal is completely cut off.
Gain Control Security Plate
The cover blocks access to the Gain settings. The LED
indicators are still visible to monitor the system's opera-
tion.
1. Use a 9/64" or 3.5 mm hex driver to loosen the screw
several turns. Do not remove it completely.
2. Slide the right end of the cover under the loosened
screw.
3. Insert the left end tabs into the last row of ventilation
slots, and slide the panel fully to the right. It should lock
into the slots.
4. Confirm that the LED's are visible through the cover.
Tighten the hex screw carefully.
CX902 shown with gain control security plate installed.
All manuals and user guides at all-guides.com
Gain controls on 2-channel models. Mark-
ings will vary depending on model.
Gain controls on 4-channel models. Mark-
ings will vary depending on model.
EN
9
Publicité
