Arm's Reach CO-SLEEPER Harmony Serie Manuel D'instructions page 5

Les langues disponibles

How to convert to Co-Sleeping position

FALL HAZARD:

Bassinet before starting any conversions.

How to attach the Arm's Reach CO-SLEEPER brand bedside bassinet to the adult bed.

To secure your CO-SLEEPER brand bedside bassinet to the adult bed, unroll safety belt from plastic anchor plate

and lay straps across the adult bed to line the center of the desired position.

The straps must now be positioned between the box spring and mattress. This can be done by sliding the straps

using a sawing motion and at the same time pulling downward until the straps and resistance anchor plate are in

their desired position.

One strap should come out on each side of the CO-SLEEPER brand bedside bassinet. Pass anchor plate strap

through the loop provided on each side of the Co-sleeper brand bedside bassinet. Connect into the female buckle

at the rear side of leg of CO-SLEEPER brand bedside bassinet.

Pulling on excess strap, tightening CO-SLEEPER brand bedside bassinet against adult bed. Repeat on other side.

Take excess strap and push it between adult mattress.

To make Arm's Reach CO-SLEEPER brand bedside bassinet higher, first measure adult bed from floor to top

of mattress. If adult bed is higher than 24", you will need to raise the CO-SLEEPER brand bedside bassinet.

For 26" high bed ,lay the bassinet on its side. On the bottom of the legs, find the leg adjustment mechanism.

Adjustment must be made for all legs in 2 inch increments .Push button and pull leg to next opening making

sure pin locks in place. Repeat for each leg. Co-Sleeper bar is now 26" high.Repeat process above for 28"

high bed.

For 30" bed, complete process for 26" & 28" height then proceed to push button & pull leg out.Making sure

adjustment button is locked into last opening. Do this for all four legs.

The leg extension feature can only be used when the Arm's Reach Co-Sleeper brand bedside bassinet is

attached to the adult bed.

Remove infant from the Arm's Reach CO-SLEEPER brand bedside

Step 1

Remove the canopy, release the velcros located on the front left and right

side. Pull fabric to expose spring lock on the right side of the removable

rail (F). Slide spring lock towards left, and drop removable rail down.

Step 2

Find the upper short fabric flap with Velcro on the front left and right side

and attach it to the corresponding one located inside the sleeping nest

and to cover the plastic female receiver on both side rails.

Step 3

The unit is now in the co-sleeping position.