Arm's Reach CO-SLEEPER Harmony Serie Manuel D'instructions page 4

® ®
How to set up the Arm's Reach CO-SLEEPER brand bedside bassinet
Step 3
（ ）
Align the back top rail H to the plastic holder located at the end of the
H
left side rail (B) as per picture, then press the head of the V-clip in the end
B
of Back top rail (H), then push the rail to the plastic holder until it locks in
place.
（ ）
I
Align the stationary rail I which has a plastic connector at both ends to
D
（
the left side leg assembly D ) as per picture, press the plastic connector
I
toward the leg tube (D) and let the leg tube (D) insert into the plastic
connector. Then secure the plastic connector and the stationary tube (I)
to the leg tube (D) by the screw (E). Do the same for the other end.
Step 4
A
Insert the left end of the front removable rail (F) into female receiver located
B
F
on the side rail assembly (B)
F
To insert the right end of the removable rail, slide the spring lock back
towards left and insert it into the right receiver. The frame of unit is now
assembled well.
Step 5
®
Attach the Velcro straps (located at the four corners outside of the
sleeping nest) around the four leg tubes to secure the nest. Also
®
attach the fabric flap with Velcro around the top side rail at both ends.
Step 6
®
Attach the Velcro straps (located at the top of the two sides of the
lining) around the top plastic female receiver to secure the lining
®
top to the frame. Then attach the Velcro on the back side of the
front panel top to the corresponding one on the top of the side skirt.
Step 7
®
Attach the Velcro located at the front left and right opening of the unit
inside of the sleeping nest.
Secure the tie of Storage basket to each leg per picture.
Step 8
Install the canopy assembly onto front and back top rail.
4