Remote Operation - Dimplex Df2426Gb Instructions D'installation

Operation
Figure 4
individual requirements, turn the
thermostat control clockwise all
the way to turn on the heater.
When the room reaches the
desired temperature, turn
the thermostat knob counter-
clockwise until you hear a click.
Leave in this position to maintain
the room temperature at this
setting. For additional heat, turn
clockwise until you hear the click
again and the heater will turn on.
Resetting the Temperature
Cutoff Switch
should the heater overheat, an
automatic cut out will turn the
fireplace off and it will not come
back on without being reset. It
can be reset by switching the
switch to "o" and
3-Position
waiting five (5) minutes before
All manuals and user guides at all-guides.com
switching the unit back on.

Remote Operation

The fireplace is supplied with an
integrated on/off remote control
To operate, push the on button
to turn fireplace on, push the oFF
button to turn the fireplace off.
operation with the remote control,
pull the plastic insulator strip out
C
CAUTION: If you need to
continuously reset the heater,
disconnect power and call
Dimplex customer service at
1-888-DImPLEX (1-888-346-
7539).
! NOTE: Ensure that the
3-Position switch is set to
the remote control setting
("=").
! NOTE: Before attempting any
B
A
11