Hilti TE 7-C Notice D'utilisation Originale page 11

extension cord if it is damaged while working. Disconnect the supply cord plug from the power
outlet. Damaged supply cords or extension cords present a risk of electric shock.
▶ Dirty or dusty power tools that have been used frequently for work on conductive materials should
be checked at regular intervals at a Hilti Service Center. Dust (especially dust from conductive
materials) or dampness adhering to the surface of the power tool may, under unfavorable conditions,
lead to electric shock.
Work area
▶ If the work involves breaking right through, take the appropriate safety measures at the opposite
side. Parts breaking away could fall out and / or fall down and injure other persons.
Personal safety
▶ Wear protective gloves. The rotary hammer may get hot during use. There is a risk of injury (cutting or
burning) if the accessory tool is touched while changing it.
3 Description
3.1 Overview of the product
3.2 Intended use
The product described is an electrically powered rotary hammer. It is designed for drilling in concrete,
masonry, drywall panel, wood, plastic and metal. The rotary hammer can also be used for light chiseling
work on masonry and surface finishing on concrete.
▶ The power tool may be operated only when connected to a power supply providing a voltage and
frequency in compliance with the information given on its type plate.
3.3 Items supplied
Rotary hammer, side handle, depth gauge, operating instructions.
Other system products approved for use with this product can be found at your local Hilti Store or online at:
www.hilti.group | USA: www.hilti.com
4 Technical data
For details of the rated voltage, current, frequency and/or input power, please refer to the power tool's
country-specific type identification plate.
When powered by a generator or transformer, the generator or transformer's power output must be at least
twice the rated input power shown on the rating plate of the power tool. The operating voltage of the
transformer or generator must always be within +5% and -15% of the rated voltage of the power tool.
*202931*
1
202931
Dust shield
@
TE-C Click chuck
;
Function selector switch
=
Control switch
%
Grip
&
Forward / reverse switch
(
Supply cord
)
Connection for the TE DRS-M dust removal
+
module
Side handle with depth gauge
§
English 5