Assembly And Operation; Applications; Removal And Installation Method Of Battery; Charging Method - Hitachi Koki WH 14DSL Instructions De Sécurité Et Mode D'emploi

APPLICATIONS

<WH14DSL>
Driving and removing of small screws, small bolts,
etc.
<WR14DSL>
Tightening and loosening of all types of bolts and
nuts, used for
items.
REMOVAL AND INSTALLATION METHOD
OF BATTERY
1. Battery removal
Hold the handle tightly and push the battery latch to
remove the battery (see Fig. 3).
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (see
Fig. 3).
Insert
Pull out
Rechargeable
Latch
battery

CHARGING METHOD

NOTE:
Before plugging into the receptacle, make sure the
following points.
The power source voltage is stated on the
nameplate.
The cord is not damaged.

ASSEMBLY AND OPERATION

securing structural
Handle
Fig. 3
WARNING:
Do not charge at voltage higher than indicated on
the nameplate.
If charged at voltage higher than indicated on the
nameplate, the charger will burn up.
1. Connect the charger's power cord to a receptacle.
When the power cord is connected, the charger's
pilot lamp will blink in red. (At 1-second intervals)
WARNING:
Do not use the electrical cord if
damaged. Have it repaired
immediately.
2. Insert the battery into the charger.
Firmly insert the battery into the charger until the
line is visible, as shown in Fig. 4 .
Pilot lamp
English
Rechargeable
battery
Charger
Line
Fig. 4
11