Zibro R 420 E Manuel D'utilisation page 59

F
R
G
F F
broken ignition coil
4
56
ADJUSTING THE WICK HEIGHT
After a period of time the combustion may no longer be high enough (Section D). In
that case you can adjust the wick height to improve the flame. To do this, the heater
must have been switched off. Follow the procedure below:
Push the OFF button ³ (Fig. L).
1
Pull the knurled wick adjustment knob · off the heater, so the wick height
2
lock will be visible.
Take the plastic collar between your thumb and index finger and pull it out.
3
Turn the collar up one step, to either position 2 or 3 (Fig. R). Carefully push
the collar back, so the pin engages in the recess.
4 Carefully reinstall the knurled wick adjustment knob. This can be done in one
way only - check the rear of the cap for the correct position.
If adjustment of the wick height does not have the required effect, let the
heater burn until all fuel has been used up (Section H).
If the flame height is still too low and the wick is set on position 3, then contact your
dealer, or replace the wick, refer to section M. If the flame gets too high after adjus-
ting (Fig P), the wick height lock should be placed one position lower again.
Otherwise smoke or soot may be caused.
MALFUNCTION, CAUSES AND SOLUTIONS
If any malfunctioning cannot be solved from the directions below, please contact
your Zibro dealer.
THE HEATER DOES NOT IGNITE
The batteries are not positioned correctly in the holder. Check (Fig. F).
There is not enough power left in the batteries for the ignition. Replace (Fig. F).
You have run out of fuel from the tank or the wick has been replaced.
After having refilled and replaced the removable tank, wait for 30 minutes
before igniting the heater.
You are pushing down the igniter slide » with too much force.
Push it down less forcefully (Section C).
The ignition coil ¸ is defective.
Contact your dealer.
IRREGULAR FLAME AND/OR SOOT AND/OR SMELLS
The combustion chamber ¿ has not been positioned correctly.
Use the handle ´ to put it level, until you can easily slide it slightly to the left
and to the right and the chamber is level.
The flame height has not been adjusted properly.
See Fig. P and the directions in Section D.
You are using fuel which is past its 'use by' date.
Start every heating season with fresh fuel.
You are using the incorrect type of fuel.
Refer to THE RIGHT FUEL (Section 'What you need to know in advance').
Dust has gathered in the lower part of the heater.
Contact your dealer.
The wick heigt is not correct.
See Section F.
THE HEATER SLOWLY EXTINGUISHES
The removable tank is empty.