Inanny NM108 Manuel D'utilisation page 12

10. What if there are problems?
"Monitor" parent unit will not
"Monitor" parent unit will
not switch on.
An acoustic signal sounds from
An acoustic signal sounds
the "monitor" parent unit.
from the "monitor" parent
unit.
The parent unit is switched on,
The parent unit is switched on,
but is not making any noise.
but is not making any noise.
The "monitor" parent unit
The "monitor" parent unit
switches itself off.
switches itself off.
The signal is weak, the
The signal is weak, the
If no transmission is possible,
connection keeps
you have the option to retune
breaking up or there is
the device signals digitally =
interference.
pairing.
If no transmission is possible,
you have the option to
retune the device signals
digitally = pairing.
Check whether
Check whether
• the mains part plug is correctly connected,
• the mains part plug is correctly connected,
•
the battery is correctly inserted,
• the battery is correctly inserted,
• the battery is full, needs charging or is damaged.
the battery is full, needs charging or is damaged.
•
Check whether
Check whether
•
the maximum range has been exceeded,
• the maximum range has been exceeded,
• the main part plug for the camera is correctly
• the mains part plug for the camera is correctly
connected,
connected,
• the camera is switched on,
•
the camera is switched on,
• the parent unit's battery needs charging.
• the parent unit's battery needs charging.
•
• To set your desired volume on the parent unit, press the
To set your desired volume on the parent unit, press
the right or left arrow buttos during operation.
right or left arrow buttons during operation.
•
Recharge the parent unit's battery,
• Recharge the parent unit's battery,
•
It could be that the parent unit is in energy-saving
• It could be that the parent unit is in energy-saving
mode. Check whether the power-saving mode has
mode. Check whether the power-saving mode has
been selected in the menu and deactivate it where
been selected in the menu and deactivate it where
necessary.
necessary.
• If another technical device such as a microwave is in
1. Switch on the camera and parent unit.
the area between the camera and the parent unit,
2. Delete the camera in the menu of the parent unit
remove the technical device or switch it off.
and the set up the camera again as described in
• Check whether other factors, such as trees or
anything else are in the area between the camera
the "Add camera" section.
and the parent unit, and change the position of the
devices until the parent unit signals a connection.
• Check whether the camera and parent unit are
inside the maximum receiving range.
1. Switch on the camera and parent unit.
2. Delete the camera in the menu of the parent unit
and the set up the camera again as described in
the "Add camera" section.
11