Publicité
Les langues disponibles
Les langues disponibles
ADJUST THE HEIGHT OF THE HANDLES :
Note: Do not remove the inner tube from the outer tube when adjusting the height of the handles.
•
To ensure that the rollator is at the correct height, stand behind the rollator with your arms at your side. Then adjust
the height of the handles to the height of the user's wrists.
WALKING WITH THE ROLLATOR :
•
When using, stand upright behind the rollator, do not bend your back.
•
Adjust the height of the handles if the position of use is not correct.
FOLD THE ROLLATOR :
a. Remove the plastic tray
b. Unlock the tray holder that is attached to the rollator frame.
c. Bring the front wheels back against the rear wheels.
The Neo Dynamic rollator is designed to stand on its own.
BRAKES ADJUSTMENT
There are two brake cable adjusters on each side of the Rollator, one in front of the brake handle and the second is positioned
on the brake lever near the rear wheel. Adjustments can be made to either binder.
•
To adjust near the handle, loosen the knob (you may need a tool to do this), and turn the adjusting screw counter-
clockwise to tighten the brake cable and then tighten the knob again.
•
For rear brake caliper adjustment, loosen the adjustment knob, (you may need a tool to perform this operation), and
turn the adjustment screw counterclockwise to tighten the brake cable, and then tighten the adjustment knob again.
For correct adjustment, the brake mechanism should not touch the wheel, but the distance between the brake pad and the
wheel should not be more than 3 to 4mm.
•
Caution : After adjusting the brakes, you must test them before using the rollator.
•
If, despite the adjustment, the brakes still do not work, do not use the rollator.
CARE AND MAINTENANCE
Failure to care for and monitor your product may result in the risk of serious injury.
•
Clean the rollator regularly with warm water and a soft cloth. Do not use abrasive products, detergents or solvents.
•
Dry with a clean, dry soft cloth.
•
Make sure there is no accumulation of dirt or debris around the axle, brakes or wheels.
•
Do not use cleaning products containing phenol or chlorine, as this could damage aluminium and polyamide materials.
•
Lubricate the wheels with a little oil if they squeak.
•
Periodically check the wear and strength of all screws and bolts. Replace all broken, damaged or worn parts im-
mediately.
•
Check that the brakes are working before each use.
•
Check the parking brakes by pushing the handles into the locked position, then trying to push the rollator.
•
If there is a malfunction, do not repair the rollator yourself. Consult an authorized dealer.
•
Checklist :
To keep the rollator in good condition, check before each use, and check regularly as follows :
Check the item
Clip and knob for height adjustment
Structural weld at wheels
Cleanliness
Screws and fasteners
Stability of frame and backrest
DMI-F-10_Annexe 2_Notice.11
Mai 2023
:
Anytime
X
Weekly
Monthly
X
X
X
X
Yearly
Page 8 sur 13
Publicité
