Publicité
Les langues disponibles
Les langues disponibles
6.
Switching Off
a)
To protect the transmitter and save power, the transmitter will turn off
automatically if it detects that the unit is not being operated or, there is weak
reception from the signal audio source, for 4 minutes. In other words, if the
signal comes back, the transmitter will work again automatically.
b)
Turn off the speaker by pressing the ON/OFF button and the LED light will
then turn off, or it will automatically turn off in approximately 4 minutes
when the transmitter turns off.
7.
Weather Conditions
a)
The rock speaker unit should be operated between the temperature range of
14
F – 122
F . Operation at temperature conditions beyond this range will likely
˚
˚
cause some damage to the unit.
b)
The rock speaker unit should be moved indoors during adverse weather
conditions such as heavy downpours, hail, snow, or at temperatures below 14
F and above 122
F .
˚
ATTENTION: The transmitter for this speaker set is designed to work with a wide
variety of devices. Our tests have shown the default volume levels of iPods, MP3
players and other devices connected to the transmitter through the headphone
jack does not have the signal strength required by the transmitter. Raising the
volume of your device will increase the signal strength to the transmitter. The
green signal LED will light when the required signal strength from your device if
reached. We recommend that you keep the volume set on your iPod or MP3
player at a minimum of ¾ of full volume.
WARNING: The Power adapters are for indoor use only. If it is wet outside or raining,
you can continue to operate your speakers via their internal batteries. Please move the
adapters out of the rain by removing them and placing them in a safe dry place. When
powering by AC household current this device must be used with the AC/DC
adapters supplied within the package. Do not try to power using other AC or DC
adapters.
All manuals and user guides at all-guides.com
P.6
8.
Re-charging battery
a)
Connect the power cable to the AC power outlet and speaker. Batteries will
automatically be re-charged.
TROUBLE SHOOTING
NO SOUND
Ensure the AC/DC adapter is fully inserted into the AC outlet and the power
-
connection input on the transmitter.
Ensure the speaker is switch ON.
-
Speaker's battery capacity is low, replace with new battery or connect the
-
AC/DC adapter to the speaker.
-
Ensure the TV or audio component is ON.
The connected audio / video equipment is not playing. Start playing the
-
equipment.
˚
The volume of speaker is too low, adjust the volume to an appropriate level.
-
DISTORTED
Press the "AUTO-TUNE" button on the speaker until matching the frequency
-
of the transmitter.
Change the position of the channel selector on the transmitter. You must
-
press the "AUTO TUNE" button on the speaker.
Ensure the volume level of speaker is adjusted properly.
-
The speaker is too far away from the transmitter, move it closer.
-
The input level of the audio signal is too low. Turn up the volume of the audio
-
source equipment.
The input level of the transmitter is too high, lower the volume of the audio
-
source equipment.
P.7
Publicité
