Publicité
Les langues disponibles
Les langues disponibles
COMPONENT IDENTIFICATION
TRANSMITTER (Not included with SPK-ROCK2)
Antenna
Signal On Indicator (green)
Power On Indicator (red)
SPEAKER RECEIVER
Power LED
Power On/Off
Volume Up/Down
IMPORTANT SAFETY INFORMATION
1. Read and understand all instructions.
2. Follow all warnings and instructions.
3. Do not use liquid or aerosol cleaners. Use a damp cloth for
cleaning. If necessary, use a mild soap.
All manuals and user guides at all-guides.com
DC Jack
Auto Tune
P.2
INSTALLATION INSTRUCTIONS
TRANSMITTER (Not applicable with SPK-ROCK2 -already set up with your
SPK-ROCK system). USE THE SAME GUIDELINES TO CONNECT YOUR ADD-ON
WIRELESS SPEAKER (SPK-ROCK2)
1.
Insert the antenna tube into the antenna wire.
2.
Connect the supplied AC/DC power adapter to an electrical wall outlet.
3.
Plug the AC/DC power adapter in the DC jack located on the rear of the transmitter.
4.
When the AC adapter is plugged in, the red POWER LED illuminates. If the red
POWER LED does not illuminate, make sure the adapter is plugged in.
5.
The rear of the transmitter has one audio cord that can be connected to audio output
jack of TV, Monitor, VCR, Radio recorder, CD/MP3/VCD/DVD/Blu-ray players or to
headphone/earphone jack with the connector provided.
When the transmitter received an audio signal, the green SIGNAL LED and the red
POWER LED will illuminate together. If the green SIGNAL LED does not illuminate,
ensure the audio source is turned on.
P.3
Publicité
